ademco vista-20p 사용자 설명서
– 28 –
Macro Key Programming & Usage
(cont’d)
The keypad beeps to acknowledge your input and
displays the command you entered (followed by “F”).
4. Enter the next command, followed by press/holding the
“D” key for at least two seconds. The keypad beeps and
displays the keystrokes entered so far.
displays the keystrokes entered so far.
5. Repeat until the all the desired commands (up to 16
characters including the “F”s) have been entered
.
Be sure to check your keystrokes before continuing. If
you made a mistake, you must start over.
6. To exit, press/hold the “D” key for at least two seconds.
The display returns to system status and indicates
system is ready.
system is ready.
Typical Macro Alpha Display:
MACRO PGM
*
#
* *
Example of Macro Programming
Suppose you want to (1) bypass the two upstairs window zones, then (2) turn on an
exterior light, and then (3) arm the security system in the AWAY mode. The procedures
in the table that follows show you how you would program this macro:
exterior light, and then (3) arm the security system in the AWAY mode. The procedures
in the table that follows show you how you would program this macro:
Function
Keystrokes Required
Keypad Display
1. Bypass zones 02 & 03
Press BYPASS [6] key, then
2-digit zone numbers 02 & 03.
2-digit zone numbers 02 & 03.
2. Insert terminator
Press the “D” key for at least 2 seconds.
*
3. Turn light on
(device 01)
Press [#] and 7 key for “device ON”, and
[01] key for selecting device 1.
[01] key for selecting device 1.
* #
4. Insert terminator
Press the “D” key for at least 2 seconds.
* # *
5. Arm system AWAY
Press AWAY [2] key.
* # *
6. Insert terminator
Press the “D” key for at least 2 seconds.
* # * *
Using a Programmed Macro Key
✱✱✱✱
DISARMED
✱✱✱✱
READY TO ARM
1.
Press the Macro key programmed for the desired
series of commands for at least 2 seconds. The “Enter
User Code” prompt appears. The prompt remains
displayed for up to 10 seconds.
User Code” prompt appears. The prompt remains
displayed for up to 10 seconds.
ENTER USER CODE
* * * *
* * * *
2. Enter your 4-digit user code.
The programmed macro sequence begins
The programmed macro sequence begins
automatically after the user code is entered.