ademco vista-20p 사용자 설명서

 

– 41 – 

Using the Test mode allows each protection point to be checked for proper operation. 

Testing should be conducted weekly to ensure proper operation. 
 

•  The keypad sounds a single beep every 60 seconds as a reminder that the 

system is in the Test mode. 

 

• 

Alarm messages are not sent to your Central Station while Test mode is on.

 

1. 

 Disarm the system and close all protected windows, 

doors, etc. The READY indicator light should come on 
if all zones are intact (i.e., all protected windows, 
doors, etc. are closed. 

✱✱✱✱

DISARMED

✱✱✱✱

 

READY TO ARM 

 

2.                    +  

5  

TEST

  then  [0] (walk) 

 (Security 

Code)

 

The Dial test (option “1”) is intended for the installer 
and should not be used unless directed to do so by your 
Security System Representative. 

1 

=

 DIAL  0 

=

 WALK 

 

 

3.  Listen. The external sounder should sound for 1 second 

and then turn off. If the sounder does not sound, CALL 
FOR SERVICE. 

TEST IN PROGRESS 

 

 

4.  Fault zones. Open each protected door and window in turn and listen for three 

beeps from the keypad. Identification (zone number or zone description) of each 
faulted protection point should appear on the display. The display clears when the 
door or window is closed. 

5.  Walk in front of any interior motion detectors (if used) and listen for three beeps. 

The identification of the detector should appear on the display when it is activated. 
The display clears when no motion is detected.  
Note that if wireless motion detectors are used, there is a 3-minute delay between 
activations. This is to conserve battery life. 

6.  Test all smoke detectors, following the manufacturer's instructions. The 

identification of each detector should appear on the display when each is activated. 

  If a problem is experienced with any protection point (no confirming sounds, no 

display), call for service immediately. 

  When all protection points have been checked and are intact (closed), there should 

be no zone identification numbers displayed on the keypad. 

7.  Exit test mode: 

                                

+    

1   

OFF

 

   

(Security Code) 

If the test mode is inadvertently left active, it automatically turns off after 4 hours. 
During the final five minutes, the keypad will emit a double beep every 30 seconds.