Alcatel-Lucent ap70 사용자 설명서
OmniAccess OAW-AP70: Installation Guide
34
Part 031644-00
May 2005
z
Otherwise, use a 4- or 8-conductor, Category 5 UTP, FE cable with male
RJ-45 connectors. The port detects MDI/MDX and automatically adjusts for
straight-through or crossover cables.
RJ-45 connectors. The port detects MDI/MDX and automatically adjusts for
straight-through or crossover cables.
N
OTE
—
Only IEEE 802.3af Power Over Ethernet is supported for manual provisioning. “Inline” or “mid-
span” POE devices will not work with the Alcatel serial breakout adapter.
The maximum length for FE cables is 100 meters (325 feet).
The OmniAccess OAW-AP70 and serial breakout adapter are plenum rated.
When is installed in an air-handling space, as described in NEC (2002) Article
300.22(C), the connecting FE cable should be suitable under NEC Article
800.50 and marked accordingly for use in plenums and air-handling spaces
with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP.
When is installed in an air-handling space, as described in NEC (2002) Article
300.22(C), the connecting FE cable should be suitable under NEC Article
800.50 and marked accordingly for use in plenums and air-handling spaces
with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP.
Install cables in accordance with all applicable local regulations and practices.
USB Port
This Universal Serial Bus port is compliant with Universal Serial Bus
Specification rev. 2.0. The USB port pin outs are:
Specification rev. 2.0. The USB port pin outs are:
External Antenna Jack
Dual band, 50ohm coaxial cable.
z
802.11a Jack
Requires a reverse polarity SMA (RP-SMA) connector. Connecting both jacks
enables antenna diversity.
enables antenna diversity.
z
802.11b or 802.11g Jack
Requires a reverse polarity SMA (RP-SMA) connector. Connecting both jacks
enables antenna diversity.
enables antenna diversity.
Pin
Description
1 (counting from
the outside edge)
the outside edge)
Power
2
Signal (negative)
3
Signal (positive)
4
Ground