Alcatel-Lucent OmniSwitch 9000 빠른 설정 가이드
May 2007
Installing the Hardware
11
Optional Rack-Mounting Hardware
All OmniSwitch 9000 Series switches are shipped with inte-
gral front rack-mount flanges. These flanges support standard
19” rack mount installations. If you have non-standard rack-
mount requirements, Alcatel-Lucent offers optional hardware
for the following applications:
gral front rack-mount flanges. These flanges support standard
19” rack mount installations. If you have non-standard rack-
mount requirements, Alcatel-Lucent offers optional hardware
for the following applications:
•
23” rack installations
•
Side-mount hardware for additional support
For information on this optional rack mounting hardware,
contact your Alcatel-Lucent representative.
contact your Alcatel-Lucent representative.
Standalone
The OmniSwitch 9000 Series switches can be installed
unmounted as a standalone unit. Be sure that the installation
location is a stable, flat surface that can accommodate the
fully-populated weight of all switches being installed. For
detailed information on weight considerations, refer to
unmounted as a standalone unit. Be sure that the installation
location is a stable, flat surface that can accommodate the
fully-populated weight of all switches being installed. For
detailed information on weight considerations, refer to
.
Note. OmniSwitch 9000 Series switches must be installed
“right side up”. Never attempt to operate a switch while it
is lying on its side.
To install the switch as a standalone unit, follow the steps
below:
below:
1
Use two or more people to move and position the
unpopulated chassis upright on the floor or bench where it
is to be installed.
is to be installed.
2
Be sure that adequate clearance has been provided for
chassis airflow and that you have placed the chassis within
reach of all required electrical outlets. For recommended
airflow allowances, refer to
reach of all required electrical outlets. For recommended
airflow allowances, refer to
. For environmental and
electrical requirements, refer to
Installing Power Supplies
Next, re-install the power supplies in the chassis power supply
bays by following the steps below:
bays by following the steps below:
1
First, be sure that you do not install the power supply
upside down. While orienting the power supply, note that
the on/off switch and power cord socket are located at the
bottom of the power supply and the fan is located at the
top of the power supply.
the on/off switch and power cord socket are located at the
bottom of the power supply and the fan is located at the
top of the power supply.
2
With one hand, grasp the handle at the front of the
power supply. Place your other hand under the power
supply casing to support its weight.
supply casing to support its weight.