Alcatel-Lucent OmniSwitch 9000 빠른 설정 가이드

Installing the Hardware

5

To protect your switch components from electrostatic 
discharge (ESD) and physical damage, read all unpacking 
recommendations and instructions carefully before beginning.

Unpack your OmniSwitch chassis as close as possible 
to the location where it will be installed. 

Network Interface (NI) modules are packaged in sepa-
rate boxes. In order to reduce significantly the expo-
sure to electrostatic discharge (ESD) and physical 
damage, do not unpack these boxes until the NI 
modules are ready to be installed.

Begin by carefully cutting the tape along the seam 

marked “OPEN HERE FIRST”.

Lift the box’s top flaps. Remove the smaller boxes that 

are enclosed and set them aside. These smaller boxes 
contain the Ship Kit and the switch’s Chassis Manage-
ment Modules (CMMs). 

Next, completely remove the white plastic handle 

inserts from the sides of the box. Removing these handles 
allows the overpack to be removed.

The overpack is the outer shell of the packaging. Lift 

the overpack straight up until it slides free from the rest of 
the packaging. This allows easy access to the chassis. 

Carefully remove the protective plastic from the switch 

chassis.

In order to reduce the weight of the chassis, it is 

recommended that you remove all factory-installed power 
supplies prior to lifting it from the packaging. Steps 7 
through 12 below provide instructions for removing power 
supplies.

Note. Steps 7 through 12 apply to power supplies that are 

newly shipped in the switch chassis. They have no power 

cords attached and the on/off switches are in the off (O) 

position. For instructions on removing power supplies that 

are currently operating in an existing switch, refer to the 

OmniSwitch 9000 Series Hardware Users Guide.

Loosen the two captive screws, located at the top and 

bottom of the power supply’s front panel. If necessary, use 
a flat-blade screwdriver to loosen the screws. Be sure that 
both captive screws are completely disengaged from the 
threaded holes in the chassis before continuing.