Alcatel-Lucent OmniAccess 3500 사용자 가이드

in the laptop, connect the laptop to a power source, and leave the laptop 
powered up for at least 2 hours. 

Your OmniAccess 3500 NLG card must be plugged into your laptop in order for you to 
be able to use the laptop.  
To remove your card from the laptop, gently pull the card out of its slot using the 
grippers on the side of the card. Strictly observe the following rules for extraction of 
the card depending on the power state of your laptop: 

•  Power On — You MUST stop the OmniAccess 3500 NLG card device on the Safely 

Remove Hardware Windows utility before you physically extract the card from 
the CardBus slot in your laptop. Failure to run the Safely Remove Hardware 
utility may compromise the future operation of your card and laptop. 

•  Standby/Hibernate/Power Off — You MAY extract the OmniAccess 3500 NLG card 

from the CardBus slot after your laptop enters the Standby, Hibernate, or Power 
Off mode. In that case, you MUST always plug the card back into the CardBus slot 
before your laptop powers up again. Failure to plug the card back in before 

power-up may compromise the future operation of your card and laptop. 

To avoid damaging your OmniAccess 3500 NLG card, always store the card in its 
protective case when it is not attached to the laptop. 

If you need assistance installing your OmniAccess 3500 NLG card, please contact your 
IT department helpdesk.