Alesis micron 사용자 설명서
B
Troubleshooting
103
If you experience problems while operating your Micron, please
use the following table to check for possible causes and solutions
before contacting Alesis customer service for assistance.
use the following table to check for possible causes and solutions
before contacting Alesis customer service for assistance.
Symptoms
Cause
Solution
The display does not light up
when the ON/OFF switch
is turned on.
when the ON/OFF switch
is turned on.
No
power.
Check that the power
adapter is plugged in
properly.
properly.
No sound.
Bad Connections.
Check your audio cables; if
necessary, swap cables.
necessary, swap cables.
Volume is turned down.
Raise the Volume knob or
Exp pedal.
Exp pedal.
Local keyboard is disabled.
In the config menu, Set Local
Control to “on.”
Control to “on.”
Change Setups to revert to
default values.
default values.
External MIDI device sent
Volume (CC#7) or
Expression (CC#11)
commands with a value
approaching 0.
Volume (CC#7) or
Expression (CC#11)
commands with a value
approaching 0.
Re-transmit
higher
values
from MIDI device.
Sustain pedal was plugged in
after power was turned on.
after power was turned on.
Turn the unit’s power off,
wait a moment, and then
turn it on again.
wait a moment, and then
turn it on again.
Notes sustain continuously.
Stuck notes due to
incomplete MIDI data.
Press the [programs] button
twice in quick succession
(double-click)
twice in quick succession
(double-click)
.
In
the
config menu, Set Local
Control to “off.”
Notes played from Micron
have a “doubled” or
“flanged” sound
have a “doubled” or
“flanged” sound
Local Control is set to “on,”
and MIDI echo/Thru is
enabled on external MIDI
device or computer.
and MIDI echo/Thru is
enabled on external MIDI
device or computer.
Disable MIDI echo/Thru
on external MIDI device.
Tempo cannot be controlled
from within the Micron.
from within the Micron.
MIDI sync is set to “on.”
In
the
config menu, Set MIDI
sync to “off” or “gen MIDI
clock.”
Alternatively, ensure that any
external devices are not
sending MIDI sync
information to the Micron.
clock.”
Alternatively, ensure that any
external devices are not
sending MIDI sync
information to the Micron.