Juniper CBL-M40-PWR-EU 사용자 설명서
Cable Connectors and Pinouts
207
Appendix A
Cable Connectors and Pinouts
This chapter contains tables that list the pinouts for the following cable connectors
on the router:
on the router:
RJ-45 Connector Pinouts for the Ethernet Management Port
The port on the craft interface labeled
MANAGEMENT ETHERNET
is an autosensing
10/100-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the
Routing Engine to a management LAN (or other device that supports out-of-band
management). For more information, see “Routing Engine LEDs and Interface Ports” on
page 19. Table 24 describes the RJ-45 connector pinout.
Routing Engine to a management LAN (or other device that supports out-of-band
management). For more information, see “Routing Engine LEDs and Interface Ports” on
page 19. Table 24 describes the RJ-45 connector pinout.
Table 24: RJ-45 Connector Pinout
Pin
Signal
1
TX+
2
TX-
3
RX+
4
Termination network
5
Termination network
6
RX-
7
Termination network
8
Termination network