Siemens SF64T353EU 전단
en
16
Optical display while
the programme is running *
the programme is running *
* depending on model
While the programme is running, a light
spot shines on the floor under
the appliance door. Do not open
the dishwasher door until the light point
is no longer visible on the floor.
If the appliance is installed at eye-level,
with flush furniture front, the light point
is not visible.
While the programme is running, a light
spot shines on the floor under
the appliance door. Do not open
the dishwasher door until the light point
is no longer visible on the floor.
If the appliance is installed at eye-level,
with flush furniture front, the light point
is not visible.
Remaining running time display
When the programme is selected, the
remaining running time of the programme
is indicated on the digital display @.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
remaining running time of the programme
is indicated on the digital display @.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
Timer programming *
* depending on model
You can delay
the start of the programme in 1 hour steps
up to 19 hours.
–
You can delay
the start of the programme in 1 hour steps
up to 19 hours.
–
Switch on the main switch (.
–
Press the timer programming
button 8 until the digital display @
jumps to
button 8 until the digital display @
jumps to
‚œ.
–
Keep pressing the timer programming
button 8 until the required time
is displayed.
button 8 until the required time
is displayed.
–
To delete the preselected starting time,
press the button 8 until
press the button 8 until
‹œ
is indicated on the digital display @.
You can change your programme
selection at any time until
the programme starts.
You can change your programme
selection at any time until
the programme starts.
End of programme
The programme has ended
when the value
when the value
‹
is indicated on the numerical display @.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
–
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
–
Open the door.
–
Hold down programme button 3
and switch on the main switch (.
and switch on the main switch (.
–
Release both buttons.
The programme button 3 flashes
and the factory-set value
The programme button 3 flashes
and the factory-set value
ƒ (half-loud)
lights up on the numerical display @.
To change the setting:
–
–
Press programme button 3. Each
time the button is pressed, the set
value increases by one level;
when the value of
time the button is pressed, the set
value increases by one level;
when the value of
„ has been reached,
the display jumps back to
‹ (off).
–
Switch off main switch (, the set
value is saved.
value is saved.
–
Close the door.
Switching off the appliance
Short time after the end of the programme:
–
–
Open the door.
–
Switch off the main switch (.
–
Turn off the tap (not applicable if Aqua-
Stop fitted).
Stop fitted).
–
Remove the utensils when they have
cooled down.
cooled down.