Siemens SF64T353EU 전단
en
19
Spray arms
Limescale and contaminants in the rinsing
water may block nozzles
and bearings on the spray arms 12
and 1:.
–
water may block nozzles
and bearings on the spray arms 12
and 1:.
–
Check outlet nozzles on the spray
arms for blockages.
arms for blockages.
–
Unscrew the upper spray arm 12.
–
Remove the lower spray arm 1:
upwards.
upwards.
–
Clean spray arms under running water.
–
Re-engage or screw on spray arms.
The majority of faults which could occur in
daily operation can be rectified by the
user. This ensures that the appliance is
quickly available for use again. The
following overview will help you locating
the causes and gives helpful advise to
eliminate them.
daily operation can be rectified by the
user. This ensures that the appliance is
quickly available for use again. The
following overview will help you locating
the causes and gives helpful advise to
eliminate them.
Note
If the appliance stops during dishwashing
or does not start for no obvious reason,
first run the Abort programme function
(Reset).
(See chapter entitled “Dishwashing”)
If the appliance stops during dishwashing
or does not start for no obvious reason,
first run the Abort programme function
(Reset).
(See chapter entitled “Dishwashing”)
ã=
Warning
Don’t forget: Repairs may be carried out
by technicians only. If a component has to
be replaced, ensure that only original
spare parts are used. Improper repairs or
use of non-original spare parts may cause
considerable damage and put the user at
considerable risk.
by technicians only. If a component has to
be replaced, ensure that only original
spare parts are used. Improper repairs or
use of non-original spare parts may cause
considerable damage and put the user at
considerable risk.
Troubleshooting