3M top coat rubbing on lacquer surfaces 사용자 설명서

Make sure the lacquer is cured properly before beginning the Top Coat Rubbing procedure.

Use the finest grit paper possible to cut down tops. Any scratches put in must be taken out to obtain the high level finishes.

Use plenty of cutting oil to obtain a consistent and even result.

Recommend loading several layers of paper on the machine to save time.

Be careful not to over cut the lacquer finish. If some orange peel or minor defects remains after coated abrasives 
cut down, the Scotch-Brite

™

Rolls and 3M

™

Finesse-it

™

Compounds step(s) should take them out.

Clean the surface between steps with a diluted soap solution (a few drops of common dish soap/liquid detergent 
in a pint of water).

If you use rags, be sure they are 100% cotton to prevent scratching the surface.

Always rub in the direction of the wood grain.

Use an adequate amount of Finesse-it compound(s) to keep the surface wet when using with the Scotch-Brite surface 
conditioning products rubbing steps.

10. Spread out the Finesse-it compound(s) evenly on the surface with the Scotch-Brite product being used before 

you begin rubbing.

11. Double loading of Scotch-Brite Clean & Finish Material Type-T may enhance results.
12. Use ebony-colored Finesse-it compounds on dark wood surfaces and ivory on light colored wood surfaces.
13. Finesse-it Final Finish Material may be applied either by hand or with Scotch-Brite High Gloss Material 

to add clarity and depth to the surface.

14. Use the Finesse-it Detail Wax; a silicone-free coating that resists marring from handling; as a final step prior to packing.

These finishes were created using a 30-pound straight-line reciprocating sander. Similar results may be achieved with other
equipment or by hand; however, the consistency of the final results may vary.

Always use protective glasses and/or face shield, as recommended in ANSI Standard Z87.1.

Use appropriate body protection such as latex or rubber gloves, safety shoes, and aprons where appropriate.

Do not exceed the maximum operating speeds stated on the product labels.

Use guards and dust collection system, if provided, with equipment.

5.

Periodically check machinery and mounting hardware to make sure they are in good operating condition. 
Repair or replace damaged machinery and mounting hardware.

Inspect product prior to installation on equipment for defects or damage.

Carefully mount product on equipment and check for proper tension and tracking.

During use, if unusual vibrations or changes occur, immediately stop the equipment. Determine the cause and correct.

Market: Woodworking
Application Description: Top Coat Rubbing on Lacquer Surfaces

High Gloss

1" thick peach

–

–

Clean & Finish - Type T

1/4" thick white

–

tale

Super Polish

1" thick white

–

–

Clean & Finish - Type S

1/2" thick dk. gray

ultra fine

silicon carbide

Detail Wax

Final Finish

Finishing Material

Compounding Material

413Q

600

401Q

1200

413Q

500

413Q

400