APRILIA scarabeo 50 ie 사용자 설명서
74
use and maintenance Scarabeo 50
- Scarabeo 100 4T
♦
Make sure that the fluid level is included
between the two “MIN” and “MAX” notches
stamped on the battery side.
between the two “MIN” and “MAX” notches
stamped on the battery side.
Otherwise:
♦
Unscrew and remove the element plugs.
Top up with distilled water only.
Do not exceed the “MAX” mark, since the
electrolyte level increases during the re-
charge.
Do not exceed the “MAX” mark, since the
electrolyte level increases during the re-
charge.
♦
Top up by adding distilled water.
After topping up, put back the element
plugs in the correct position.
plugs in the correct position.
♦
Put back the element plugs.
REMOVING THE BATTERY
Carefully read page 72 (BATTERY).
ACCESS TO BATTERY
♦
Make sure that the ignition switch is in po-
sition “
sition “
”.
♦
Lift the saddle, see page 24 (UNLOCKING
/ LOCKING THE SADDLE).
/ LOCKING THE SADDLE).
♦
Remove the battery cover (1).
The battery is connected to the electrical
wires. Do not force the wires while remov-
ing the battery.
wires. Do not force the wires while remov-
ing the battery.
COMPLETE REMOVAL
♦
Disconnect first the negative (-) and then
the positive cable (red) (+).
the positive cable (red) (+).
♦
Detach the breather pipe.
♦
Remove the battery from its compartment
and put it on a flat surface, in a cool and
dry place.
and put it on a flat surface, in a cool and
dry place.
Once it has been removed, the battery
must be stored in a safe place and kept
away from children.
must be stored in a safe place and kept
away from children.
CHECKING
THE ELECTROLYTE LEVEL
THE ELECTROLYTE LEVEL
Carefully read page 72 (BATTERY).
♦
Remove the battery (see REMOVING THE
BATTERY).
BATTERY).
CAUTION
WARNING
CAUTION
CAUTION
MAX
MIN
1
100
1