Avaya S8500 사용자 설명서

About this book
Trademarks

To reduce the risk of electric shock or energy hazards:

This equipment must be installed by trained service personnel in a restricted-access 
location, as defined by the NEC and IEC 60950, Third Edition, The Standard for Safety of 
Information Technology Equipment.

Connect the equipment to a reliably grounded safety extra low voltage (SELV) source. An 
SELV source is a secondary circuit that is designed so that normal and single fault 
conditions do not cause the voltages to exceed a safe level (60 volts direct current).

The branch circuit overcurrent protection must be rated at a minimum of 5 amperes to a 
maximum of 15 amperes.

Use 14 American Wire Gauge (AWG) or 2.5 mm2 copper conductor only, not exceeding 
three meters in length.

Torque the wiring-terminal screws to 12 inch-pounds (1.4 newton-meters).

The power-control button on the device does not turn off the electrical current supplied to 
the device. The device might also have more than one connection to dc power. To remove 
all electrical current from the device, ensure that all connections to dc power are 
disconnected at the dc power input terminals.

 All trademarks identified by the ® or 

TM

 are registered trademarks or trademarks, respectively, of Avaya 

Inc. All other trademarks are the property of their respective owners.

The following are trademarks or registered trademarks of Avaya:

AUDIX

®

Cajun

®

Callvisor

®

Callmaster

®

CentreVu™

CONVERSANT

®

DEFINITY

®

DIMENSION

®

INTUITY™