HP 5187-2725 사용자 설명서
Cold-Installing HP-UX 11i v2
Cold-installing HP-UX 11i v2
Chapter 5
88
a. Select
SecurityChoices
. The four security configuration bundles
appear. By default,
Sec00Tools
is selected.
b. Select
Sec30DMZ
from the list.
c. Select
OK
.
Step 9. Pre-Install disk information, Step 1. There are two steps involved in the
pre-install checks. The first is to identify which disks will be overwritten
during the install process. If you see a disk in the list that you do not
want included, back up to the root disk selection and choose another
disk. Otherwise, continue on to the next step.
during the install process. If you see a disk in the list that you do not
want included, back up to the root disk selection and choose another
disk. Otherwise, continue on to the next step.
Step 10. Pre-Install check information, Step 2. The second step in the pre-install
check is to review any errors, warnings, or notes. Warnings are simply
informational. If there are any errors, they will need to be resolved
before the installation can continue.
informational. If there are any errors, they will need to be resolved
before the installation can continue.
Step 11. System summary. At this point you have successfully defined your
system. Use the
Show Summary
button to view a summary of how your
system will be configured. If you see any problems, or wish to change any
of your selections, feel free to back up to the appropriate step, and make
the needed changes. Otherwise, select
of your selections, feel free to back up to the appropriate step, and make
the needed changes. Otherwise, select
Finish
(at the bottom of the tabs).
You have the chance to
Cancel
at this time. If you cancel, you can start
again.
Step 12. Next, the installation will begin with filesets being copied from the
media to the hard disk. The system will automatically reboot during the
installation process.
installation process.
Step 13. Depending on how you set up your parameters, the system will either set
basic network configurations automatically, or will call the
set_parms
command after it has rebooted to allow you to set the root password, date
and time, time zone, IP address, and additional network parameters.
and time, time zone, IP address, and additional network parameters.
After
set_parms
is executed, then the “Welcome to HP-UX” screen will
be displayed.
Step 14. In order to use a keyboard on this interface, you must specify a language
mapping which will be used by X Windows and the Internal Terminal
Emulator (ITE). Choose the appropriate language. For English, select
number
Emulator (ITE). Choose the appropriate language. For English, select
number
26
.