HP designjet l65500 매뉴얼
9.
Slide the takeup core onto the lower axle. It clicks into place.
NOTE:
If the cleaner roll has not been properly installed, you may see a message about clearing
a printhead cleaning roll jam. Pull the whole assembly out, wind a little of the roll forward, then slide
it back in again. The printer will check the roll again
it back in again. The printer will check the roll again
10.
Restore the pinch system by moving the black knob back into place. If you feel resistance because
the cleaning roll is too tight, turn the roll slightly counter-clockwise.
the cleaning roll is too tight, turn the roll slightly counter-clockwise.
11.
Grip the handle and push the whole printhead cleaning roll assembly back into the printer.
12.
Close the door.
Do not empty the drain container: this is done by a service engineer during preventive maintenance.
Replace the aerosol filters
1.
Open the printhead access door in the side of the printer, and lift the carriage cover.
2.
The aerosol filter containers are on the near and the far sides of the printheads.
26
Chapter 4 Hardware maintenance
ENWW
Hardwa
re ma
int
enance
enance