HP laserjet 1018 서비스 매뉴얼
The printer feeds multiple sheets or jams frequently from the main input tray or priority input slot.
Cause
Solution
The paper guides are not adjusted correctly or the paper is
not far enough forward.
not far enough forward.
Slide the guides against the sides of the stack in the main
input tray or the priority input slot to center the paper. Make
sure that the guides are not adjusted too tightly.
input tray or the priority input slot to center the paper. Make
sure that the guides are not adjusted too tightly.
The stack is not neat or not aligned well on all sides.
Remove the media, and then align stack and replace it.
The main input tray is overfilled.
Remove some of the sheets. The main input tray can hold
up to 250 sheets of 75 g/m
up to 250 sheets of 75 g/m
2
(20-lb) bond-weight paper (less
for heavier paper) or from 20 to 30 envelopes.
The priority input slot is overfilled.
Remove media or feed single sheets. The priority input slot
is designed for optimal feeding of single sheets, especially
when heavier media is used. It can hold up to ten sheets of
75 g/m
is designed for optimal feeding of single sheets, especially
when heavier media is used. It can hold up to ten sheets of
75 g/m
2
(20-lb) bond-weight paper (one sheet of heavier
paper) or one envelope.
The paper was poorly cut by the manufacturer and is
sticking together.
sticking together.
“Break” the ream of paper by curving it into an upside-down
u-shape; this can effectively decrease multifeeds. Also try
turning the paper around to feed the opposite end first, or
use a different type of paper.
u-shape; this can effectively decrease multifeeds. Also try
turning the paper around to feed the opposite end first, or
use a different type of paper.
The paper does not meet HP specifications for print media.
Make sure that the media meets the specifications detailed
in the HP LaserJet Printer Family Print Media Guide.
in the HP LaserJet Printer Family Print Media Guide.
The output capacity was exceeded in the output bin.
Do not allow more than 125 sheets of 75 g/m
2
(20-lb) bond-
weight paper (less for heavier paper) to fill the paper output
bin.
bin.
The pickup roller is dirty.
Clean the pickup roller.
The pickup roller is damaged.
Replace the pickup roller.
The separation pad is damaged.
Replace the separation pad.
A sensor is not operating correctly.
The chances of a sensor failing are very small. However,
debris around the sensor arms can cause them to register a
jam. Three sensors are in the printer: top-of-page sensor,
paper-width sensor, and delivery sensor. Check them to
ensure that the sensor arms can move freely. On the rare
occasion of a failed sensor, replace the printer.
debris around the sensor arms can cause them to register a
jam. Three sensors are in the printer: top-of-page sensor,
paper-width sensor, and delivery sensor. Check them to
ensure that the sensor arms can move freely. On the rare
occasion of a failed sensor, replace the printer.
Table 6-4
Solving paper-feed problems (continued)
106
Chapter 6 Troubleshooting
ENWW