HP laserjet 1018 서비스 매뉴얼
Paper-pickup assembly
1.
Remove the following assemblies.
●
.
●
Left-side cover. See
.
●
Top-cover assembly. See
●
Transfer roller. See
●
Fuser (fixing) assembly. See
2.
Disconnect and unwind any additional wires as necessary to release the paper-pickup
assembly. Unplug and unwind the wire from the solenoid to the formatter.
assembly. Unplug and unwind the wire from the solenoid to the formatter.
Disconnect and unwind any additional wires as necessary to release the paper-pickup
assembly. Unplug and unwind the wire from the solenoid to the formatter.
assembly. Unplug and unwind the wire from the solenoid to the formatter.
CAUTION
Do not pull directly on the wires when a connector is disconnected. Always
pull on the plastic body of a connector to avoid damaging the connector wires.
3.
Remove six screws (callout 1), and then remove the paper-pickup assembly.
1
Figure 5-27
Remove the paper-pickup assembly
Reinstallation tip
When replacing the paper-pickup assembly, be sure to transfer the
sensor PCB and, if necessary, the separation-pad assembly to the new paper-pickup
assembly.
assembly.
ENWW
Internal assemblies
79