HP officejet d 사용자 설명서
load originals and load paper
16
hp officejet d series
2
Tap the stack on a flat surface to align the edges of the paper, and
then check the paper for the following:
–
then check the paper for the following:
–
Make sure it is free of rips, dust, wrinkles, and curled or bent
edges.
edges.
–
Make sure all the paper in the stack is the same size and type,
unless you are working with photo paper.
unless you are working with photo paper.
3
Insert paper into the main tray print-side down until it stops. If you are
using letterhead, insert the top of the page first.
Be careful not to use too much or too little paper. Check that the stack
of paper contains several sheets but is no higher than the top of the
paper-length guide.
using letterhead, insert the top of the page first.
Be careful not to use too much or too little paper. Check that the stack
of paper contains several sheets but is no higher than the top of the
paper-length guide.
4
Slide the paper-width and paper-length guides in until they stop at the
edges of the paper. Make sure that the paper stack lies flat in the
main tray and fits under the tab of the paper-length guide.
edges of the paper. Make sure that the paper stack lies flat in the
main tray and fits under the tab of the paper-length guide.
5
Lower the output tray.
6
To prevent printed paper from falling off the tray, fully extend the
output-tray extender.
output-tray extender.