Canon 1827B001 사용자 설명서

21

This machine has a USB connector and LAN connector. If the machine is connected to a network using a 
LAN cable, you can print the documents sent from a computer, send documents to a file server and send 
document attached to an e-mail through a network.

The machine does not come with a LAN cable.

Connect a Category 5 or greater twisted pair LAN cable to the 10Base-T/100Base-TX port on the 
back of the machine. Connect the other end of the cable to a network router or a hub.

If you use the machine as a local printer, connect the machine directly to a computer using a USB cable. 
(See “Installing/Uninstalling Software,” on p. 25.)

An IP address must be specified in order to enable communication between the machine and a 
computer.

– It is recommended that the network administrator perform the following procedures.
– Before performing the following procedure, make sure that the machine is turned on and connected to a network.
– This machine is set by default to automatically draw an IP address using DHCP. If your network server or router is 

configured to provide a DHCP address, all you need to do is connect a network cable and turn on the machine. The 
machine will draw an IP address automatically.

– This machine also supports automatic IP addresses using BOOTP and RARP protocols. If you use these protocols, select 

<ON> at step 6 of the following procedures, then specify the <2. BOOTP> or <3. RARP> settings. 

Press [Additional 
Functions].

Press [

] or [

] to 

select <11. SYSTEM 
SETTINGS>

, then press 

[OK].

Press [

] or [

] to 

select <5. NETWORK 
SETTINGS>

, then press 

[OK].

PC with

10Base-T Connector

PC with

100Base-TX Connector

Hub

Ethernet Cable

22