HP photosmart 7550 사용자 설명서

1

unpack your hp printer

2

plug in the power cord

3

load plain paper in the IN tray

1.  Lift the OUT tray.
2.  Pull out the paper length guide on the IN tray. 
3. Slide the paper width guide as far to the left as it

will go.

4.  Move the photo tray slider toward you until it stops.

This disengages the photo tray. 

5. Place a stack of plain paper into the IN tray.
6.  Adjust the paper width guide and paper length guide

to fit close to the edges of the paper without bending

the paper.

7.  Lower the OUT tray.

1.

OUT tray

4.

Photo tray slider

2.

Paper length guide

5.

IN tray

3.

Paper width guide

Setup Guide

Documentation

Software and

Printer Help on CD

HP #57

HP #58

Print cartridges

Power cord

3.

Print cartridge cradle latch

1.

Power button

2.

Side door

4.

Plastic tape

5.

6.

7.

Calibration page

Q1605-90198

Printer

Copper contacts

1.

2.

3.

HP #56

Power module

4

install the print cartridges

1. Press the Power button to turn the printer on.
2. Insert your forefinger behind the notch on the

left side of the side door and pull out to open

the door. 

3. Pop open each print cartridge cradle latch by

pulling out the bottom of the latch.

4. Remove the plastic tape from each print

cartridge. 

5. Insert each print cartridge so the copper

contacts go in first. 
Insert the HP #56 black print cartridge in the

right stall. 

Insert the HP #57 tri-color print cartridge in the

middle stall. 
Insert the HP #58 photo print cartridge in the left

stall. 

6. Close each print cartridge cradle latch by

pulling out the bottom of the latch, pressing

down, then releasing the latch. 

7. Close the side door and press the OK button. 

A calibration page prints automatically. This

verifies that the print cartridges are installed

correctly.

hp photosmart 7550

setup

guide

!

Windows PC:

Be sure to insert the HP

Photosmart CD before you

connect the printer to your

computer with the USB cable.