HP procurve 2500 사용자 설명서

    112

Configuring RADIUS Authentication and Accounting

radius-server retransmit < 1 .. 5 >

Where the switch has multiple RADIUS servers configured to support authentication requests, if the 
first server fails to respond, then the switch tries the next server in the list, and so-on. If none of the 
servers respond, then the switch attempts to use the secondary authentication method configured 
for the type of access being attempted (console, Telnet, or SSH). If this occurs, see “Troubleshooting 
SSH Operation” on page 101.

For example, suppose that your switch is configured to use three RADIUS servers for authenticating 
access through Telnet and SSH. Two of these servers use the same encryption key. In this case your 
plan is to configure the switch with the following global authentication parameters:

■

Allow only two tries to correctly enter username and password.

■

Use the global encryption key to support the two servers that use the same key. (For this 
example, assume that you did not configure these two servers with a server-specific key.)

■

Use a dead-time of five minutes for a server that fails to respond to an authentication request.

■

Allow three seconds for request timeouts.

■

Allow two retries following a request that did not receive a response.