HP qms 1660e 사용자 설명서

다운로드
페이지 314
Updating
System
Software
QMS 1660E Print System Reference
6-84
printer reboots with the new system image, prints a start-up page, 
and returns to 
IDLE
.
»
Note: 
The new flash image does not erase the old image until the 
printer verifies that the new image is valid.
6
Print another advanced status page, and verify that the cur-
rent configuration settings match the previous configuration 
settings (on the advanced status page printed in step 1).
7
If there are differences in the configuration settings, correct 
them through the printer configuration menu.
PC
Serial Port
This method for downloading the system software from an IBM or 
compatible PC should be used only when a parallel port is not avail-
able because it’s slower and because it requires a null modem cable 
(see the “Cable Pinouts” section of appendix B, “Technical Specifica-
tions,” for more information) and special software to set the PC’s 
serial port to 38400 baud (see step 2, below). 
After you have decompressed the system software, as described in 
an earlier section, use the following procedure to update the system 
software in flash memory.
»
Note: 
If you’re using a parallel port, refer to the previous section, 
“PC—Parallel Port.”
1
Connect the PC to the printer’s serial port, using a null 
modem cable.
2
Download the DOS ModeX program from the QMS Bulletin 
Board.
Using your modem, dial in to the QMS Bulletin Board, as 
described in appendix A, “QMS Customer Support.” After you 
access the QMS Main Library through the L (Library of Files) 
selection, do the following:
a
Choose D (Download a File).
b
Type 
hibaud.exe
c
Exit from the Bulletin Board.