Canon imageclass 2300n 네트워크 가이드

Setting Up a Computer for Printing

Using a 

TCP/IP Netw

o

rk

 (Windo

ws/UNIX)

NOTE

•

The admintool utility, SAM utility, and SMIT utility belong to the operating systems. 
For specific operating instructions, see the operating system manual.

•

The above procedures are only examples. The setup procedures for your 
environment may differ.

•

You can specify a print queue. The following three print queues are available (be 
sure to use only capital letters to enter a print queue):
- LP: The machine prints according to its spool settings. Normally enter "LP" as a 

print queue.

- SPOOL: The machine prints only after spooling a print job on the hard disk 

regardless of its spool settings.

- DIRECT: The machine prints without spooling a print job on the hard disk 

regardless of its spool settings.

The host computer settings are complete.

Check the IP address range settings in the Remote UI to see 
whether the IP address of the computer in which a printer 
driver is to be installed is permitted. (See Chapter 2, "Remote 
UI Functions," in the Remote UI Guide.)

IMPORTANT

•

If the IP address range settings do not permit the IP address, you cannot install a 
printer driver.

•

If the IP address of the computer is beyond the range of the permitted addresses in 
the IP Address Range Settings menu in the Remote UI, you cannot print from the 
computer.

NOTE

For Windows 95/98/Me: Install the IPP Client software for Windows 95/98/Me 
provided by Microsoft, and then restart your computer.

❑

On the [Start] menu, point to [Settings] 

➞ click [Printers].

❑

Double-click the [Add Printer] icon.