Canon imageclass 2300n 네트워크 가이드

NetWare Print Service Settings

Using a NetW

a

re Netw

o

rk

 (Windo

ws)

To print using a NetWare network, you need to specify print service settings, 
including the print server and queue settings. You can use any of the software listed 
below to specify the print service settings from your computer. Specify the settings 
using the easiest method.

•

NetSpot Device Installer (Canon software included on the Network User Software 
CD-ROM)

•

NetSpot Console (via a web browser) (Canon software included on the Network 
User Software CD-ROM)

•

NWADMIN or PCONSOLE (Novell software provided with NetWare)

IMPORTANT

•

To specify the print service settings from NetSpot Console or NWADMIN, the computer 
must have Novell Client (NetWare Client by Novell) installed.

•

The following procedures explain a sample NetWare setup procedure. Depending on 
your environment, the actual setup procedure may differ.

Before specifying print service settings, refer to the following descriptions to 
determine the type of print service you are using.

NOTE

•

Normally with NetWare 4.x or later, it is recommended that you use NDS print service. 
With NetWare 3.x, it is recommended that you use Bindery print service. This manual 
describes procedures for these two combinations only.

•

With NetWare 5.x, you can use NDPS (Novell Distributed Print Services). If using NDPS, 
the gateway should be the Novell printer gateway provided with NetWare. This manual 
does not describe NDPS settings. For NDPS settings, see the NetWare manual.

■

This machine supports both NDS and Bindery mode.
Determine the appropriate mode according to the network environment you are using. (If 
you are using NetWare 3.x, only the Bindery mode is available.)