Canon imageclass 2300n 사용자 가이드

 

Transmission Settings

Additional Sending F

eatures

 

 

 

This section describes how to set the pause time (in seconds).

Some overseas dialing may not be successful due to the distance or complex route 
of connections when you dial the international access code, country code, and the 
destination number all together. In such cases, insert a pause after the international 
access code. The machine dials the number with a short waiting time where the 
pause has been inserted, which helps improve the connection.

Follow this procedure to adjust the length of a pause entered within a dialed 
number.

IMPORTANT

 

 

 

If your machine is connected to a switchboard or PBX (Private Branch Exchange), you 
may have to dial a number to connect to an outside line. The outside number must also 
be registered with the fax number. The switching system may also require that you insert 
a pause after the outside number. For further assistance, contact your service 
representative or local telephone company.

NOTE

 

 

 

 

Keep in mind the following important points about pauses:
- A pause entered within a number (p) is two seconds long.
- You can add consecutive pauses (pp) by pressing [Pause/Redial].
- Each additional pause adds two seconds to the pause time.
- You can change the length of a pause entered within a number (see the procedure 

below).

- A pause at the end of a number (P) is always 10 seconds long and cannot be adjusted.

 

 

The default setting is '02SEC'.

 

➞

 

▼

 

▲

 

➞

 

The FAX SETTINGS menu appears.