Canon imageclass 2300n 사용자 가이드
Placing Originals
3-7
Basic Sending
3
Orientation
You can place an original either vertically or horizontally. Always align the top edge
of your original with the back edge of the platen glass (by the arrow in the top left
corner), or with the back edge of the feeder.
of your original with the back edge of the platen glass (by the arrow in the top left
corner), or with the back edge of the feeder.
IMPORTANT
If the top edge of the original is not aligned with the back edge of the platen glass (by the
arrow in the top left corner), prints may not be made correctly, depending on the mode
you have set.
arrow in the top left corner), prints may not be made correctly, depending on the mode
you have set.
If an original is scanned facing the wrong direction, the sender information is not printed
in the correct position on the fax.
in the correct position on the fax.
NOTE
LTR originals can be placed either vertically or horizontally. However, the scanning speed
for horizontally placed originals is somewhat slower than for vertically placed originals.
for horizontally placed originals is somewhat slower than for vertically placed originals.
Horizontally placed LTR originals are referred to as LTR .
11" x 17" and LGL originals must be placed horizontally.
To get the same output result when you are using the feeder as when the original is
placed on the platen glass, place the original upside-down and face up in the feeder.
placed on the platen glass, place the original upside-down and face up in the feeder.
Feeder
Platen Glass
Vertical Placement
Vertical Placement
Horizontal Placement
Horizontal Placement
Place the
original
face down.
TX Terminal ID
Printed Here
Place the original face down.
TX Terminal
ID Printed
Here
ID Printed
Here
ABC
Place the
original
face up.
TX Terminal ID
Printed Here
ABC
Place the
original
face up.
original
face up.
TX Terminal ID
Printed Here
Printed Here