Siemens SE24M258EU 전단
Maintenance and care
For perfect rinsing results ...
Cleaning the waste-water pump *
Strainers ...
Check, if
required, clean
required, clean
Rotate filter
cylinder, remove
filter system ...
cylinder, remove
filter system ...
rinse under
flowing water ...
flowing water ...
Insert ...
Screw in filter
system NOTE
MARK!
system NOTE
MARK!
* With some models
– Ladle out water and remove filters
– Unscrew cover (Torx T20)
– Check area of fan impeller for foreign objects
– Screw in cover and insert filters
– Unscrew cover (Torx T20)
– Check area of fan impeller for foreign objects
– Screw in cover and insert filters
Spray arms ...
Remove
blockages/deposits
blockages/deposits
Pull lower arm
upwards ...
upwards ...
Unscrew upper
arm ...
arm ...
Clean spray nozzles
under flowing water
(perhaps with
toothpick) ...
under flowing water
(perhaps with
toothpick) ...
Insert lower arm ...
Screw in upper arm
Rectifying minor faults yourself ...
... as it is worth doing it yourself!
Fault
Possible causes
Appliance is not running /
stops
stops
Check water supply
Display lights up
Display lights up
Supply fitting not open
Supply hose kinked
Supply fitting jammed or calcified
Open supply fitting.
Install supply hose without kinks.
1. Unscrew water connection.
2. Clean filter in the water connection.
3. Flow rate must be min. 9 l/min. when
water supply is open.
If the flow rate is less, replace the
supply fitting.
2. Clean filter in the water connection.
3. Flow rate must be min. 9 l/min. when
water supply is open.
If the flow rate is less, replace the
supply fitting.
Remedial action
Plastic / utensils
discoloured
discoloured
Too little detergent
Discoloration caused by food colourings
(tomato sauce)
(tomato sauce)
Follow manufacturer’s instructions
(detergent).
(detergent).
Discoloration is harmless; subsequent
rinse cycles will cause it to fade.
rinse cycles will cause it to fade.
Residual water
in the appliance
in the appliance
Waste water pump blocked
The programme has not yet ended
Clean waste-water pump (see above).
Close appliance and switch on.
or terminate programme (see
Terminating the programme).
or terminate programme (see
Terminating the programme).
Rust on the cutlery
Cutlery not rust-resistant
Hard knife blades are more susceptible
Hard knife blades are more susceptible
Extraneous rust
Use dishwasher-proof cutlery.
Never wash rusting parts
in the appliance.
in the appliance.
Fault
Possible causes
Remedial
action
action
Stains and streaks
Milky film on the utensils
(removable)
(removable)
Rinse-aid dosage too high / too low
Glasses not dishwasher-proof.
Streaks: reduce dosage.
Water or limescale stains: increase
dosage.
dosage.
Use dishwasher-proof glasses.
Use a detergent suitable for glasses.
More information can be found in the operating instructions
Milky film, glasses
cloudy / dull
(not removable)
cloudy / dull
(not removable)
Water softening system incorrectly set;
No salt
Correctly set water softening system.
Refill with salt.
Utensils are not clean
Sand or gritty residue
on the utensils
on the utensils
Utensils are situated close together
or one above the other
or one above the other
Too little detergent
Unsuitable programme selected
Spray arm nozzles blocked
Filters dirty, not seated firmly
Spray arms blocked
Separate the utensils, prevent contact
points.
points.
Follow manufacturer’s instructions
(detergent).
(detergent).
Select a more intensive programme.
Clean the spray arms (see above).
Clean the filters (see above).
Arrange the utensils so that the spray
arms can rotate freely.
arms can rotate freely.
Stopping the programme ...
Loading the dishwasher correctly ...
Press and hold the two
reset buttons simultaneously for
approximately 3 seconds while
the programme is running
(RESET)
reset buttons simultaneously for
approximately 3 seconds while
the programme is running
(RESET)
”0” appears
The programme will stop
after 1 minute
after 1 minute
Switch off the appliance.
Arrange dishwasher-proof utensils (having removed any ash, wax, grease, ink, sticky labels; remove,
large remnants of jam, dairy products and food) according to the operating instructions and check that
the spray arms can rotate freely.
large remnants of jam, dairy products and food) according to the operating instructions and check that
the spray arms can rotate freely.