Juniper CBL-M40-PWR-AU 사용자 설명서
Install the Router and Configure Software
Install the Router without Using a Mechanical Lift
117
Reinstall the Upper Impeller Assembly
The upper impeller assembly is located at the top rear of the chassis, above the fan tray (see
Figure 2). To reinstall it, follow this procedure (see Figure 44):
Figure 2). To reinstall it, follow this procedure (see Figure 44):
1.
Attach an ESD strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
the chassis.
2.
Grasp the handle at the top of the assembly and slide the assembly all the way into the
chassis.
chassis.
3.
Using a Phillips screwdriver, tighten the thumbscrews at the lower corners of the
assembly.
assembly.
Figure 44: Reinstall the Upper Impeller Assembly
Reinstall the Routing Engine Housing
The Routing Engine resides in a metal housing in the rear of the chassis, below the fan tray
(see Figure 2). To reinstall the Routing Engine housing, follow this procedure (see Figure 45):
(see Figure 2). To reinstall the Routing Engine housing, follow this procedure (see Figure 45):
1.
Attach an ESD strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
the chassis.
2.
Place one hand underneath the unit to support it and grasp a handle on the front of the
unit with the other hand.
unit with the other hand.
3.
Align the rear of the unit with the slide guides in the chassis.
4.
Slide the unit completely into the chassis.
5.
Using a Phillips screwdriver, tighten the screws along the left and right edges of the
Routing Engine housing (six in all).
Routing Engine housing (six in all).
1054