Juniper CBL-M40-PWR-AU 사용자 설명서
Routing Engine
M40 Internet Router Hardware Guide
16
LED—Indicates disk activity for the internal IDE interface. It does not necessarily
indicate routing-related activity.
The LEDs that report Routing Engine status are
on the craft interface
rather than the
Routing Engine faceplate. See “Routing Engine LEDs and Interface Ports” on page 19.
Reset button—Reboots the Routing Engine when pressed.
Extractor clips—Control the locking system that secures the Routing Engine in the
chassis.
Figure 6: Routing Engine
The appearance and position of electronic components or
the PC card slot on your Routing Engine might differ from
the figures in this section. These differences do not affect
Routing Engine installation and removal or functionality.
the PC card slot on your Routing Engine might differ from
the figures in this section. These differences do not affect
Routing Engine installation and removal or functionality.
For specific information about components in a Routing
Engine (for example, the capacity of the hard disk), issue
the
Engine (for example, the capacity of the hard disk), issue
the
show chassis routing-engine
command.
Although the Routing Engine has a PC card slot, it is
disabled on the M40 router. The router instead uses an
LS-120 disk.
disabled on the M40 router. The router instead uses an
LS-120 disk.
JUNIPER NETW
ORKS LABEL
THIS SIDE
1596
Extractor clip
PC card slot
RESET
HD
P
C
C
A
R
D
Extractor clip
PC card slot
LED
Extractor clip
Extractor clip
LED
Routing Engine 333
Routing Engine 600