Sony CDP-CE545
Additional Information
28
GB
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output
Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ±0.5 dB
Dynamic range
More than 93 dB
Harmonic distortion
Less than 0.0045%
Output
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
,Check that the player is connected securely.
,Make sure you operate the amplifier correctly.
,Adjust the output level using the ANALOG
,Make sure you operate the amplifier correctly.
,Adjust the output level using the ANALOG
OUT LEVEL +/– buttons on the remote.
The CD does not play.
,There’s no CD inside the player (“–NO DISC–”
appears). Insert a CD.
,Place the CD with the label side up on the disc
tray correctly.
,Clean the CD (see page 27).
,Moisture has condensed inside the player.
,Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 27).
for about an hour (see page 27).
,Place the CD in the correct position on the disc
tray.
The remote does not function.
,Remove the obstacles in the path of the remote
and the player.
,Point the remote at the remote sensor on the
player.
,Replace all the batteries in the remote with new
ones if they are weak.
,Set the CD 1/2/3 switch on the remote
according to the command mode of the player.
The player functions incorrectly.
,The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
back on to reset the player.
ANALOG OUT
DIGITAL OUT
(OPTICAL)
(OPTICAL)
PHONES
Jack
type
type
Phono
jacks
jacks
Optical
output
connector
output
connector
Stereo
phone jack
phone jack
Maximum
output
level
output
level
2 V
(at 50 kilohms)
(at 50 kilohms)
–18 dBm
10 mW
Load
impedance
impedance
Over 10 kilohms
Wave length: 660 nm
32 ohms
General
Power requirements
Where purchased
Canada
Europe and some Asian
countries
countries
Other countries
Power consumption
11 W
Dimensions (approx.)
430
×
110
×
398 mm
(w/h/d)
(17
×
4 3/8
×
15 3/4 in.) incl. projecting
parts
Mass (approx.)
5.1 kg (11 lbs 4 oz.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Power requirements
120 V AC, 60 Hz
220 V - 230 V AC, 50/60 Hz
110V - 120 V or 220 V - 240 V AC,
adjustable, 50/60 Hz
adjustable, 50/60 Hz