Sony DTC-ZE700 사용자 설명서
7
EN
3-
858
-189-11(1)
Basic Operations
Basic Operations
5
Locate the position where you want to start recording.
To record from the beginning of the tape
Press
0 to rewind the tape to its beginning.
To record from the end of the recorded portion
1 Press
0 to rewind the tape to its beginning.
2 Press
).
The deck locates the end of the recorded portion on the tape
and stops automatically.
and stops automatically.
6
Press
r REC.
The deck becomes ready to record.
7
When recording the analog input signal, adjust the recording
level with REC LEVEL.
level with REC LEVEL.
The recommended recording level is 3. For details, refer to
“Adjusting the Recording Level for Analog Recording” on
page 10.
“Adjusting the Recording Level for Analog Recording” on
page 10.
8
Press
P or ·.
Recording starts.
9
Start playing the program source.
When the tape reaches the end, the deck rewinds it
automatically to its beginning and stops (Auto Rewind).
automatically to its beginning and stops (Auto Rewind).
To
Press
Stop recording
Pause recording
P. Press the button again to resume
recording.
recording.
p
Recording is
impossible (the
hole is open).
impossible (the
hole is open).
Recording is
possible (the
hole is closed).
possible (the
hole is closed).
Take out the cassette
To prevent accidental erasure
Slide the record-protect tab to the left as shown in the illustration below.
OPEN/CLOSE
§ after stopping recording
z
If “UNLOCK” appears in the
display
display
The program source is not
connected to the deck
properly or is not turned on.
Make sure that the program
source is properly connected
or turned on.
connected to the deck
properly or is not turned on.
Make sure that the program
source is properly connected
or turned on.