Sony DVP-PR30 사용자 설명서
13
H
ook
up
s
s
7
Press X/x to select the setting that
matches your TV type.
matches your TV type.
◆ If you have a wide-screen TV or a 4:3
standard TV with a wide-screen mode
• 16:9 (page 28)
◆ If you have a 4:3 standard TV
• 4:3 LETTER BOX or 4:3 PAN SCAN
standard TV with a wide-screen mode
• 16:9 (page 28)
◆ If you have a 4:3 standard TV
• 4:3 LETTER BOX or 4:3 PAN SCAN
8
Press ENTER.
The Setup Display for selecting the type
of video signal output from the LINE
(RGB)-TV jack appears.
of video signal output from the LINE
(RGB)-TV jack appears.
9
Press X/x to select the type of
signal you want to output from the
signal you want to output from the
LINE (RGB)-TV jack.
10
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your audio
component such as an amplifier
(receiver) appears.
of jack used to connect your audio
component such as an amplifier
(receiver) appears.
11
Press X/x to select the type of
jack (if any) you are using to
connect to an audio component,
then press ENTER.
If you did not connect an audio
component, select “NO,” then go to step
15.
If you connected an audio component
using coaxial digital cable, select “YES:
DIGITAL OUTPUT.”
component, select “NO,” then go to step
15.
If you connected an audio component
using coaxial digital cable, select “YES:
DIGITAL OUTPUT.”
12
Press X/x to select the type of
Dolby Digital signal you wish to
send to your audio component.
If your audio component has a Dolby
Digital decoder, select “DOLBY
DIGITAL.” Otherwise, select “D-PCM.”
Digital decoder, select “DOLBY
DIGITAL.” Otherwise, select “D-PCM.”
13
Press ENTER.
“DTS” is selected.
14
Press X/x to select whether or
not you wish to send a DTS signal
to your audio component.
to your audio component.
If your audio component has a DTS
decoder, select “ON.” Otherwise, select
“OFF.”
decoder, select “ON.” Otherwise, select
“OFF.”
15
Press ENTER.
Quick Setup is finished and connections
are complete.
If your audio component has an MPEG
audio decoder, set “MPEG” to “MPEG”
(page 31).
are complete.
If your audio component has an MPEG
audio decoder, set “MPEG” to “MPEG”
(page 31).
SCREEN SETUP
TV TYPE:
SCREEN SAVER:
BACKGROUND:
SCREEN SAVER:
BACKGROUND:
16:9
ON
JACKET PICTURE
LINE:
VIDEO
VIDEO
S VIDEO
RGB
NO
YES
Is this player connected to an amplifier
(receiver) ?
(receiver) ?
DIGITAL OUTPUT
AUDIO SETUP
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
MPEG:
STANDARD
ON
DOWNMIX:
DOLBY SURROUND
DOLBY DIGITAL
DTS:
D-PCM
48kHz/96kHz PCM:
48kHz/16bit
DOLBY DIGITAL
AUDIO SETUP
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
MPEG:
STANDARD
ON
DOWNMIX:
DOLBY SURROUND
DOLBY DIGITAL
PCM
DTS:
48kHz/96kHz PCM:
48kHz/96kHz PCM:
OFF
OFF
ON