Sony dvpsr510h 사용자 설명서

If you experience any of the following 
difficulties while using the player, use this 
troubleshooting guide to help remedy the 
problem before requesting repairs. Should 
any problem persist, consult your nearest 
Sony dealer.

c Check that the power cord is connected 

securely.

c Re-connect the connecting cord securely.
c The connecting cords are damaged.
c Check the connection to your TV and switch 

the input selector on your TV so that the signal 
from the player appears on the TV screen.

c The disc is dirty or flawed.
c Press [/1 to turn off the player, and enter 

“369” using the number buttons on the remote, 
then press [/1 to turn on the player again.

c Re-connect the connecting cord securely.
c The connecting cord is damaged.
c The player is in pause mode or in Slow-motion 

Play mode.

c The player is in fast forward or fast reverse 

mode.

c The batteries in the remote are weak.
c The remote is not pointed at the remote sensor 

 on the player.

c When you operate the player by pressing 

buttons on the remote in sequence, press the 
buttons within 5 seconds of each other.

c The disc is turned over. 

Insert the disc with the playback side facing 
down.

c The disc is skewed.
c The player cannot play certain discs.
c The region code on the DVD does not match 

the player.

c Moisture has condensed inside the player.
c The player cannot play a recorded disc that is 

not correctly finalized.

c When static electricity, etc., causes the player 

to operate abnormally, unplug the player.

c Clean the disc with a cleaning cloth or check 

its format.

c Change the “HDMI RESOLUTION” setting 

in “HDMI SETUP.” The problem may be 
solved.

c The equipment connected to the HDMI OUT 

jack does not conform to the audio signal 
format, in this case set “AUDIO (HDMI)” in 
“HDMI SETUP” to “PCM.”

c Try the following: 1Turn the player off and 

on again. 2Turn the connected equipment off 
and on again. 3Disconnect and then connect 
the HDMI cord again.

Video: MPEG-1 (Cyber-shot data)
Photo: JPEG (DCF format)
Music: MP3 (except for mp3PRO)/WMA 
(except for WMA Pro)*

1, 

*

2

/AAC*

1, 

*

2

/

LPCM/WAVE

*

1

Files with copyright protection (Digital Right 
Management) cannot be played.

*

2

The player does not play coded files such as 
Lossless.

Supported extensions: “.mpg”, “.mpeg”, 
“.jpg”, “.mp3”, “.wma”, “.m4a”, “.wav”
Supported discs: DVD, DVD

±RW/±R/±R 

DL, Music CD/Super VCD, CD-R/-RW

• DATA CDs recorded according to ISO 

9660 Level 1/Level 2, or its extended 
format, Joliet.

• DATA DVDs recorded according to UDF.
• The player will play any file in the above, 

even if the file format differs. Playing such 
data may generate noise that can result in 
speaker damage.

• To play a complex hierarchy of folders may 

take some time. Create albums with no 
more than two hierarchies.

• Some video, photo, and music files may not 

play, depending on the encoding/recording 
condition.

• To start playback and proceed to the next or 

another album/file may take some time.

,continued