Sony MHC-GRX40AV 사용자 설명서
40
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, both channels driven, from
70 – 20,000 Hz; rated 60 watts per channel
minimum RMS power, with no more than
0.9% total harmonic distortion from
250 milliwatts to rated output.
HARMONIC DISTORTION:
With 6 ohm loads, both channels driven, from
70 – 20,000 Hz; rated 60 watts per channel
minimum RMS power, with no more than
0.9% total harmonic distortion from
250 milliwatts to rated output.
Amplifier section
MHC-RXD6AV (North American model):
Front Speaker:
Continuous RMS power output (reference)
Front Speaker:
Continuous RMS power output (reference)
70 + 70 watts
(6 ohms at 1 kHz,
10% THD)
(6 ohms at 1 kHz,
10% THD)
Total harmonic distortion less than 0.07%
(6 ohms at 1 kHz, 35 W)
Center Surround Speaker:
Continuous RMS power output (reference)
Continuous RMS power output (reference)
30 watts
(12 ohms at 1 kHz,
1% THD)
(12 ohms at 1 kHz,
1% THD)
Rear Surround Speaker:
Continuous RMS power output (reference)
Continuous RMS power output (reference)
15 + 15 watts
(6 ohms at 1 kHz,
1% THD)
(6 ohms at 1 kHz,
1% THD)
MHC-RXD6AV (European model):
Front Speaker:
DIN power output (rated) 50 + 50 watts
Front Speaker:
DIN power output (rated) 50 + 50 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference)
60 + 60 watts
(6 ohms at 1 kHz,
10% THD)
(6 ohms at 1 kHz,
10% THD)
Music power output (reference)
100 + 100 watts
(6 ohms at 1 kHz,
10% THD)
(6 ohms at 1 kHz,
10% THD)
Specifications
Tuner
Severe hum or noise (“TUNED” or
“STEREO” flashes in the display).
“STEREO” flashes in the display).
•Adjust the antenna.
•The signal strength is too weak. Connect
•The signal strength is too weak. Connect
the external antenna.
A stereo FM program cannot be received in
stereo.
stereo.
•Press STEREO/MONO so that
“STEREO” appears.
If other troubles not described
above occur, reset the system as
follows:
above occur, reset the system as
follows:
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press 1/u.
4 Press p and 1/u at the same time.
The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.
2 Plug the power cord back in.
3 Press 1/u.
4 Press p and 1/u at the same time.
The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.
Troubleshooting (continued)