Sony STR-DG820 사용자 설명서

F:\SONY SEM\Models_2008\Revision_Data\PMRF3_STR-
DG820\JC080765_3289450431DG820_GB\3289450431\GB03CON_STR-DG820-CEL.fm

STR-DG820

3-289-450-43(1)

Press .

Perform the Auto Calibration again.

When you press 

, “RETRY? YES” appears.

Press 

V/v to select “RETRY? YES”, then press 

.

Perform the Auto Calibration again.

If a warning on the measurement result is 
present, detailed information is displayed.

“Confirming/saving the 
measurement results” (page 33).

You can use the AUTO CAL menu to make 
various adjustments for Auto Calibration 
settings and to name inputs.
Select “AUTO CAL” in the amplifier menus. 
For details on adjusting the parameters, see 
“Navigating through menus” (page 42) and 
“Overview of the menus” (page 43).

x A.CAL START (Auto Calibration)

x CAL TYPE (Calibration type)*

• FULL FLAT

Makes the measurement of frequency from 
each speaker flat.

• ENGINEER

Sets the frequency characteristics to a set 
that matches that of the Sony listening room 
standard.

• FRONT REF

Adjusts the characteristics of all speakers to 
match the characteristics of the front 
speaker.

• OFF

Sets the Auto Calibration equalizer level to 
off.

* You can select this parameter only when you have 

performed the Auto Calibration and saved the 
settings.

x POSITION (Position)

You can register 3 patterns as position 1, 2 and 
3 (POS. 1, POS. 2 and POS. 3), depending on 
the seating position, listening environment and 
measurement conditions. You can also load 
the registered setting.

x NAME IN (Naming inputs)

You can rename the position name. For 
details, see “Naming inputs” (page 80).