Sony SVT-S480ES 사용자 설명서
47
3
Press MENU + or – to set the date and press
MENU B to move the flashing to the time. Press +
or – to set the time. Set the minute (when NEW is
selected) on the same way.
MENU B to move the flashing to the time. Press +
or – to set the time. Set the minute (when NEW is
selected) on the same way.
4
Press FF M or REW m.
The cassette stops at the portion when you set the
time and date and the still picture playback is
displayed.
The time/date search mode is automatically
cleared.
The cassette stops at the portion when you set the
time and date and the still picture playback is
displayed.
The time/date search mode is automatically
cleared.
Notes
• When T/D SEARCH is set to NEW on the GENERAL
SET menu, the time/date search mode works during
recording in from 2H to 96H (when using T-120 tape)
mode, from 2H to 128H (when using T-160 tape) mode in
the SP mode, or from 6H to 168H (when using T-120 tape)
mode, from 8H to 224H (when using T-160 tape) mode in
the EP mode.
recording in from 2H to 96H (when using T-120 tape)
mode, from 2H to 128H (when using T-160 tape) mode in
the SP mode, or from 6H to 168H (when using T-120 tape)
mode, from 8H to 224H (when using T-160 tape) mode in
the EP mode.
• If the tape reaches its end during searching, the tape is
rewound and the unit enters the stop mode at the beginning
of the tape.
of the tape.
• Be sure to set T/D SEARCH on the GENERAL SET menu
to the same setting as the tape was recorded with.
Otherwise, searching for the time and date cannot be done
properly.
Otherwise, searching for the time and date cannot be done
properly.
• You can use the T/D SEARCH only when the alarm speed
is set to SP 2H (when using T-120 or T-160 tape in SP
recording mode), EP 6H (when using T-120 tape in EP
recording mode), or EP 8H (when using T-160 tape in EP
recording mode) and the recorded section is longer than 20
seconds.
recording mode), EP 6H (when using T-120 tape in EP
recording mode), or EP 8H (when using T-160 tape in EP
recording mode) and the recorded section is longer than 20
seconds.
1
Turn on the power of the equipment to be used.
2
Press SEARCH/AUDIO ON in stop mode until the
time/date search indicator flashes in the display
window and on the monitor screen.
When CONVENTION is selected for T/D
SEARCH on the GENERAL SET menu:
time/date search indicator flashes in the display
window and on the monitor screen.
When CONVENTION is selected for T/D
SEARCH on the GENERAL SET menu:
When NEW is selected for T/D SEARCH on the
GENERAL SET menu:
GENERAL SET menu:
In the display window
1 H 1 2 M 0 6 S
T / D S E A R C H
0 1 1 2
Hour
Date
On the monitor
In the display window
1 H 1 2 M 0 6 S
T / D S E A R C H
0 1 1 2 2 0
Minute
On the monitor
Hour
Date
1
4
2
3
Searching for the Time and Date