Sony UP-DF500 사용자 설명서

Pre

par

at

ion

Connections

9

You can place the unit vertically if you attach the casters 
provided. This is convenient for placing the unit under a 
desk and to pull it out easily.

• Ask your nearest Sony dealer to attach the casters to 

the unit.

• Use the casters to allow the unit to be pulled out from 

under the desk and so on. Be sure not to use the casters 
for moving the unit on an uneven surface.

• Place the stopper sheet (supplied) under a unit with 

casters attached.

• When pulling the unit in and out while the unit is 

equipped with the casters provided, be careful not to 
damage the power cord, LAN cable, and so on.

• When placing the unit vertically, make sure the LCD 

is near the floor, and leave a space of more than 8 cm 
(3 1/4 inches) between the top of the unit and the 
subject to prevent blocking the ventilation holes.

Connect the unit to the 100BASE-TX LAN.

• Connect the AC power cord last.
• Before connecting to the LAN, be sure to set up the 

required IP address and sub-net mask.
For detailed information, consult the system 
administrator.

• Before connecting the unit using a 100BASE-TX 

cable, attach the ferrite cores provided to both ends of 
the cable for noise prevention.
For detailed information on how to attach the ferrite 
cores, see “How to attach the ferrite cores” (on 
page 10)

Fix the front caster using the stopper sheet 
(supplied).
Be sure to place the roller of the caster in the groove 
of the stopper sheet.

Fix the unit using the front caster.

Stopper sheet

100BASE-TX cable 

a)

to the LAN

Power cord (supplied)

to

-

 AC IN

to the network connector

a) Be sure to use a network cable of less 

than 30 m in length, and rated more than 
category 5.