Panasonic AJ-SPX800E 사용자 설명서

While pressing down the slide lock button, move the slide-
out door to the left. 
The door opens.

Tilt down the EJECT button.

Then, depress the EJECT button to release the P2 card so
that you can remove it.

z When a P2 card is being accessed or it is being recognised

after insertion (P2 CARD ACCESS LED blinks in orange), do
not remove the P2 card.
If your AJ-SPX800E is not set to turn on the P2 CARD
ACCESS LED, before removing the card ensure that pre-
recording and/or voice memo recording have finished (the P-
REC indication has stopped blinking and the V mark or VOICE
REC indication on the viewfinder screen has turned off) after
stopping recording or playback.

z If a P2 card being accessed is removed, the viewfinder

displays “TURN POWER OFF” and the AJ-SPX800E gives a
warning using an alarm and the WARNING LED. In addition,
all P2 CARD ACCESS LEDs blink rapidly in green. If this is the
case, turn the power off. For more information on warning
indications, see “7-3 Warning System”.

z If a P2 card is removed while being accessed, clips on it may

become irregular although the data will not be corrupted.
Check the clips and restore them if required. For more
information about how to restore clips, see “6-9 Restoring
Clips”.

z If a P2 card being formatted is removed, it may be not be

formatted properly. In this case, the viewfinder displays “TURN
POWER OFF”. If this message appears, turn off the power,
then restart the AJ-SPX800E to reformat the card.

z If a P2 card is inserted while another P2 card is being played

back, the inserted P2 card is not recognised and the P2 CARD
ACCESS LED for that card does not come on. Card
recognition starts when the playback ends. 

The P2 CARD ACCESS LEDs may be set to stay off using the
menu option ACESS LED. This option can be found on the
<SYSTEM MODE> screen, which is accessible from the
SYSTEM SETTING page.

To prevent the content of a P2 card being accidentally erased,
position the write-protect switch on the P2 card at [Pprotect].

Write-protect switchover can be performed while the card is
being accessed (during recording or playback), but does not
take effect until access to the card ceases.

* The mode check indication is shown in the viewfinder. For more

information, see [4-7-2 Viewfinder Status Indication Layout].

Stays on in green ACTIVE

Writing and reading enabled

Stays on in 
orange

ACTIVE

Writing and reading enabled. 
The card is recordable (loop 
recording also enabled).

Stays on in 
orange or green

ACTIVE !

Writing and reading enabled. 
However, some clips 
recorded on the P2 card may 
not be able to be read 
successfully.

Blinks in orange

ACCESSING

Writing or reading being 
performed.

Quickly blinks in 
green

INFO READING

The P2 card is being 
recognised. 

Blinks in green

FULL

The P2 card has no free 
space. Only reading is 
enabled. 

PROTECTED

The write-protect switch on 
the P2 card is positioned at 
[PROTECT]. Only reading is 
enabled. 

Stays off

NOT 
SUPPORTED

The card is not supported by 
your AJ-SPX800E. Replace 
the card.

FORMAT ERROR

The P2 card is not properly 
formatted. Reformat the 
card.

NO CARD

No P2 card is inserted.

Protect