Panasonic cx-dp880n 사용자 설명서
11
8
E
N
N
G
L
I
S
H
H
CX-DP880N
10
7
E
N
N
G
L
I
S
H
H
CX-DP880N
Caution: Connect the battery lead to the battery line via the car-side fuse. Do not share the power line that con-
nects to the battery directly such as the line to an external power amplifier.
nects to the battery directly such as the line to an external power amplifier.
Q’ty
Item
No.
Wiring Accessory
u
Extension Cord (DIN/BATT/RCA/GND)
1
Electrical Connection
1. This product operates only in a 12-volt DC negative ground system.
2. Before performing installation and wiring, remove the negative (–) terminal of the battery.
2. Before performing installation and wiring, remove the negative (–) terminal of the battery.
Supplied Hardware
Caution: Do not disconnect the negative battery termi-
nal in vehicles with trip or navigational computers. All
electronic memory settings previously registered will be
lost.
Take extra care to avoid short circuiting when installing
the unit.
nal in vehicles with trip or navigational computers. All
electronic memory settings previously registered will be
lost.
Take extra care to avoid short circuiting when installing
the unit.
3. Follow the wiring connections diagram carefully to avoid causing damage to the unit.
4. Insulate all exposed wires to prevent short circuiting.
5. Secure all loose wires after installing the unit.
6. Connect the power lead after all otehr connetions are made.
7. Please carefully read the operating and installation instructions of any equipment connected to this unit.
4. Insulate all exposed wires to prevent short circuiting.
5. Secure all loose wires after installing the unit.
6. Connect the power lead after all otehr connetions are made.
7. Please carefully read the operating and installation instructions of any equipment connected to this unit.
Installation
Preparations
In combination with the cassette receiver (CQ-RD153N)
Caution: We strongly recommend that you wear gloves for installation work to protect yourself from
injuries.
injuries.
Cassette Receiver
CQ-RD153N
Ground Lead
To a clean, bare metallic
part of the car chassis.
To a clean, bare metallic
part of the car chassis.
Fuse 3A
(“Fuse Replacement”
(“Fuse Replacement”
a
page15 )
RCA Cord (R)
(R)(Red)
(L)(White)
RCA Cord (L)
Changer Control Connector
DIN cord
Power Connector
Battery Lead*
To the car battery, continuous +12V DC
To the car battery, continuous +12V DC
Antenna
(Yellow)
(Black)
uExtension Cord
(DIN/BATT/RCA/GND)
(DIN/BATT/RCA/GND)
CD Changer
CX-DP880N
Be sure to connect to a well grounded
metallic part of your car because noises or
troubles may occur.
metallic part of your car because noises or
troubles may occur.
Qty
Diagram
Item
No.
Hex. Bolt with Double Washers (M4 x 8 mm)
q
4
Base Bracket
w
2
Hex. Nut (M5)
e
4
Mounting Bracket (L)
r
1
Mounting Bracket (R)
t
1
Double-Faced Adhesive Tape
y
2
Extension Cord (DIN/BATT/RCA/GND)
u
1
*If this connection is unnec-
essary, cut the plug off.