Panasonic dvd-rv60 사용자 설명서

42

VQT8626

When an error or trouble is detected during operation, a message appears in the FL display.
When a message has appeared, check the details given below.

This function works only for Video CDs with playback control. 

7

≥

If the message fails to be cleared, even when remedial action is taken, ask a service technician to repair the player.

Message

∑∑

∑∑

stands

for a number.

Player status

Disc is dirty.

Trouble is likely to have occurred. The
number following “H” differs depending on
the status of the player.

Remedy

Wipe the disc clean.

Press [

Í

/I] to switch the player to the standby mode and then

back to ON. Alternatively, press [

Í

/I] to switch the player to the

standby mode, disconnect the AC mains lead, and then reconnect
it.

Subtitles appear only with discs which contain them.
Subtitles are cleared from the TV monitor. Display the subtitles. 

B

 

I

An alternative language is not selected with discs which do not contain more than one language.
In the case of some discs, the alternative language cannot be selected by operating the [AUDIO] or
[SUBTITLE]. Try selecting it from the disc’s menu if one is available. 

@

This function is dependent on software availability. Even if a disc has a number of angles recorded,
these angles may be recorded for specific scenes only (when “ANGLE” lights up on the player’s FL
display).

If the soundtrack and/or subtitle language does not exist on the disc, the language selected at the
initial settings will not be seen/heard.

The setup “3 Menus” of “1 Disc Languages” is set to French: Select English. 

L

Check the connections. 

9

 

:

 

QjT

If you have connected this player to an amplifier through the audio output terminals, go to the initial
settings menu “8 Speaker Setting” and change the settings to suit your speakers. Select “Yes” for all
the speakers you have connected. 

W

If you have connected this player to an amplifier (with built-in decoder) through the digital audio
output terminal, go to the initial settings menu “7 Digital Audio Output” and change the settings to
“Bitstream” for “2 Dolby Digital” or “3 DTS Digital Surround”. 

U

Sound will only come from the two front speaker if V.S.S. is on. Turn V.S.S. off. 

G

While stopped, press and hold [

:

] and [

;

] on the player and then also press and hold [

<

] on the

player until “Initialized” disappears from the television (after about 3 seconds).
All initial settings will return to the default values.

You have selected an audio channel that includes a vocal channel. Read the disc’s jacket to choose
the correct channel. 

A

When you have connected this unit to other equipment through a DIGITAL AUDIO OUT terminal, go
to “7 Digital Audio Output” in the initial settings and change the setting for ”2 Dolby Digital” to “PCM”.

Q SjV

Most Karaoke DVDs are designed to do this. Some discs have an item in the menu that allows you
to play all the songs.