Panasonic kx-tcd280fx 사용자 설명서
Useful Information
60
SMS (Short Message Service)
Answering system (KX-TCD290 only)
Problem
Cause & solution
I cannot send or receive SMS
messages.
messages.
L
You have not subscribed to the appropriate service.
Consult your service provider.
Consult your service provider.
L
The SMS message centre number(s) are not stored
or are incorrect. Store the correct numbers.
or are incorrect. Store the correct numbers.
L
Message transmission was interrupted. Wait until
the message has been sent before using other
telephone functions.
the message has been sent before using other
telephone functions.
L
38).
L
Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
“FD” is displayed.
L
The unit could not connect to the SMS message
centre. Confirm that the correct SMS message
centre numbers are stored. Confirm that SMS is
turned on (page 36).
centre. Confirm that the correct SMS message
centre numbers are stored. Confirm that SMS is
turned on (page 36).
“FE” is displayed.
L
An error occurred while sending the message. Try
again.
again.
“E0” is displayed.
L
Your phone number is permanently withheld or you
have not subscribed to the appropriate service.
Consult your service provider.
have not subscribed to the appropriate service.
Consult your service provider.
“Q” is not displayed after you read
a message. An error code (“FD”,
“FE”, or “E0”) is displayed.
a message. An error code (“FD”,
“FE”, or “E0”) is displayed.
L
When an error code is displayed, “Q” will not be
displayed even if you have read the message.
displayed even if you have read the message.
Problem
Cause & solution
The other party complains that they
cannot leave a message.
cannot leave a message.
L
The recording time is set to “Greeting Only”.
Select “1 Minute” or “3 Minutes” (page 47).
Select “1 Minute” or “3 Minutes” (page 47).
L
Message memory is full. Erase unnecessary
messages (page 44).
messages (page 44).