Panasonic WJ-GXE900 사용자 설명서

47

Perform the settings for each alarm type and the alarm
notification.

Note: Click the [SET] button to save the changed

settings. Otherwise, the changed settings will not be
saved.

■ Item Descriptions
ALARM SETUP

Perform the settings for each alarm type in detail.
Click the button of the desired alarm type to go to the
respective setting page.

Setting of the action performed when the ALARM IN
connector on the rear panel receives an alarm signal.

Setting of the action performed when the VIDEO IN
connector on the rear panel receives an alarm signal
from a camera or a receiver which can overlap the
alarm output signal with the video signal.

Setting of the action performed when video loss
occurs. (When the encoder detects that no video
signal is supplied, the encoder regards it as the video
loss. Video loss occurs when a camera is
malfunctioning, the power of the camera is off, a wire
is broken, there is connection trouble, etc.)

Enter an IP address and a port number to be send
an alarm notification command when an alarm (dry
contact, camera site alarm or video loss alarm)
occurs. The alarm notification command has
information on the alarm type and the time and date
of the alarm occurrence.
1024 to 65535 are available for the "ALARM
NOTIFICATION PORT No.".
The default settings of the "ALARM NOTIFICATION
IP ADDRESS" and the "ALARM NOTIFICATION
PORT No." are as follows.
ALARM NOTIFICATION IP ADDRESS: 0.0.0.0
ALARM NOTIFICATION PORT No.: 51456