Panasonic WJ-GXE900 사용자 설명서

73

Note: It is necessary to restart the decoder to save the

changed settings. Otherwise, the changed settings
will not be saved. Restarting the decoder can be
done on the MAINTENANCE page. Click the
[MAINTENANCE] button in the left column to go to
the MAINTENANCE page and click the [RESTART]
button on the MAINTENANCE page. It will take
around 2minutes for the decoder to become operable
after the restart.

■ Item Descriptions

Perform the following settings after referring to a network
administrator about the setting items.

Enter the IP address of the decoder.
The default setting is "192.168.0.11".

Enter the subnet mask of the decoder to connect to a
network.
The default setting is "255.255.255.0".

Enter the default gateway to connect to a network.
The default setting is "192.168.0.1".

Enter the IP address of the DNS server to connect to
a network.
No IP address is entered as the default setting.

The MAC address of the decoder will be displayed.
It is impossible to change this value.

Select a transmission speed between the decoder
and a network device such as a switching hub or a
router from the following.
AUTO: Transmission speed will be automatically set.
100BASE-TX FULL DUPLEX: Sending and

receiving data will be performed simultaneously.

100BASE-TX HALF DUPLEX: Sending and

receiving data will be performed alternately.

1000BASE-T: When selecting this, use an enhanced

category 5 (STP (Shielded Twisted Pair)) cable to
connected to the network.