Gateway 7450R 사용자 설명서
Replacing and Adding Internal Devices
43
Expansion cards
The server has two expansion slots on the riser card that can be used for a
variety of expansion cards. These slots support 64-bit, 66 MHz PCI cards. Both
slots will hold full-length, full-height cards.
variety of expansion cards. These slots support 64-bit, 66 MHz PCI cards. Both
slots will hold full-length, full-height cards.
Replacing an expansion card
You must install an expansion card in slot 1 before you can install an
expansion card in slot 2.
expansion card in slot 2.
To replace an expansion card:
1
Set any jumpers and switches on the replacement card, if required in the
card instructions.
card instructions.
2
Turn off the server, then disconnect the power cord and all external
peripheral devices.
peripheral devices.
3
Open the case. See “Opening the case” on page 18 and “Preventing static
electricity discharge” on page 17.
electricity discharge” on page 17.
4
Disconnect any cables attached to the old card.
5
Remove the screw that holds the expansion card bracket in place.
Expansion card
Screw
Expansion card bracket
8507328.book Page 43 Thursday, February 15, 2001 11:28 AM