Gateway 820 LTO 사용자 설명서
30
Chapter 4: Operating the Autoloader
www.gateway.com
The Operator’s Panel
The Operator’s Panel consists of:
■
Status LEDs
■
LCD
■
Keypad
Status LEDs
The LEDs are updated during power up and reset sequences. When you turn
on the autoloader or do a software reset, the autoloader turns on all LEDs as
soon as the power-on self-test (POST) allows.
on the autoloader or do a software reset, the autoloader turns on all LEDs as
soon as the power-on self-test (POST) allows.
When mechanical initialization starts, all LEDs turn off and the
READY/ACTIVITY LED flashes at rate of approximately one second per cycle.
When the mechanical initialization is complete, the READY/ACTIVITY LED
stops flashing.
READY/ACTIVITY LED flashes at rate of approximately one second per cycle.
When the mechanical initialization is complete, the READY/ACTIVITY LED
stops flashing.
If a loader failure occurs, the READY/ACTIVITY LED turns off and the error LED
turns on. The Operator’s Panel also displays an appropriate error code to help
identify the failure.
turns on. The Operator’s Panel also displays an appropriate error code to help
identify the failure.
X
X
X
X
--
+
+
Ready/activity LED
Clean Drive LED
Media attention LED
Error LED
LCD
Enter
Previous
Next
Cancel