JVC GR-D20 사용자 설명서

EN

!
@

9

4

)

r
#

● Make sure to set “S/AV INPUT” to “OFF” in the Menu

Screen (GR-D50/D30 only, 

墌

 pg. 24).

● Set the video out select switch of the cable adapter as

required:
Y/C

: When connecting to a TV or VCR which accepts

Y/C signals and uses an S-Video cable.

CVBS : When connecting to a TV or VCR which does not

accept Y/C signals and uses an audio/video
cable.

● When editing on a VCR equipped with a DV input

connector, an optional DV cable can be connected
instead of an S-Video cable and audio/video cable.

$

Connect when an S-Video cable is not used.

** When connecting cables, open this cover.
*** Provided with the optional Remote Control kit

RM-V717KITU.

Connector
cover**

*

(

)

If using a Fade/Wipe at the beginning of the scene,

press FADE/WIPE 

9

 on the remote control.

• Cycle through the effects by pressing repeatedly, and

stop when the one you want is displayed.

At the beginning of the scene, press EDIT IN/OUT

@

 on the remote control. The Edit-In position appears

in the Random Assemble Editing Menu.

At the end of the scene, press EDIT IN/OUT 

@

. The

Edit-Out position appears in the Random Assemble
Editing Menu.

If using a Fade/Wipe at the end of the scene, press

FADE/WIPE 

9

.

• Cycle through the effects by pressing repeatedly, and

stop when the one you want is displayed.

• If you select a Fade/Wipe effect for an Edit-Out point,

the effect is automatically applied to the following
Edit-In point.

• When you use Fade/Wipe effects, that time is

included in the total time.

If using Playback Special Effects, press EFFECT 

!

(

墌

 pg. 28).

Repeat steps 6 through 9 to register additional

scenes.

• To change previously registered points, press

CANCEL 

#

 on the remote control. The registered

points disappear, one at a time, from the most
recently registered point.

• If you are not using Fade/Wipe or Programme AE with

special effects, repeat steps 6 and 7 only.

● When choosing a scene, set Edit-In and Edit-Out points

so that there is a relatively large difference between
them.

● If the search time for an in-point exceeds 5 minutes, the

recording deck’s Record-Standby mode will be cancelled
and editing will not take place.

● If there are blank portions before or after the Edit-In and

Edit-Out points, a blue screen may be included in the
edited version.

● Since time codes register time only as accurately as

seconds, the time code total time may not match the total
programme time exactly.

● Turning off the camcorder’s power erases all registered

Edit-In and Edit-Out points.

Point the remote control at the camcorder’s remote

sensor. Press PLAY (4) 

)

 and then press R.A.EDIT

ON/OFF 

r

 on the remote control.

The Random Assemble Editing Menu appears.

  01 D50/40/30/20EK 28-33

02.12.4, 19:12

31