JVC KD-S35 사용자 설명서

GET0563-002A

[J]

You need the installation kits which corresponds to your car.
•  Mark all the check boxes ( 

 ) to make sure you have follow the instructions and the listed parts.

1

0508DTSMDTJEIN
EN, SP

© 2008 Victor Company of Japan, Limited

  ENGLISH

  ESPAÑOL

•  The fuse blows.
*  Are the red and black leads connected correctly?

•  Power cannot be turned on.
*  Is the yellow lead connected?

•  No sound from the speakers.
*  Is the speaker output lead short-circuited?

•  Sound is distorted.
*  Is the speaker output lead grounded?
*  Are the “–” terminals of L and R speakers grounded in common?

•  Noise interfere with sounds.
*  Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?

•  This unit becomes hot.
*  Is the speaker output lead grounded?
*  Are the “–” terminals of L and R speakers grounded in common?

•  This unit does not work at all.
*  Have you reset your unit?

A

/

B

Hard case/
Control panel

C

Sleeve

D

Trim plate

E

Power cord

K

Handles

J

Rubber cushion

I

Mounting bolt—
M4 × 5 mm (M4 × 1/4"); 
M5 × 12.5 mm (M5 × 1/2")

H

Lock nut (M5)

G

Washer (ø5)

L

Remote controller

M

Battery

Install the unit at an angle of 
less than 30˚.

Screw (option)

Stay (option)

Fire wall

Dashboard

*  Not supplied for this unit.

Flat type screws
—M5 

× 8 mm (M5 × 3/8")*

Pocket

Flat type screws
—M5 

× 8 mm (M5 × 3/8")*

Bracket

*

Bracket

*

Before removing the unit, release the rear section.

In a Toyota car for example, first remove the car radio and install the unit in its place.

Do the required electrical 
connections.

Bend the appropriate tabs 
to hold the sleeve firmly 
in place.

When you stand the unit, be careful 
not to damage the fuse on the rear.

  If you are not sure how to install this unit correctly, consult your JVC car audio dealer.

F

Direct connection 
cable for iPod

Install_EN_KD-S35[J]_1.indd   1

Install_EN_KD-S35[J]_1.indd   1

6/5/08   4:41:33 PM

6/5/08   4:41:33 PM