Toshiba ASD-G9ETH 사용자 설명서

 

  

14

ICC 

This interface card has been designed for quick and simple installation.  The 
card is connected to the drive's control board via a 30-pin rectangular 
connector, and is mechanically supported via an integral housing that 
seamlessly mates with the drive’s enclosure.  The only tool required for 
installation is a flat-blade screwdriver. 
 
Before opening the drive, please observe all safety precautions as outlined on 
the drive's front cover and in the operation manual. 
 
 

1. 

 

  Verify that all input power sources to the drive 

have been turned OFF and are locked and tagged out. 

2. 

 

 

 Wait at least 5 minutes for the drive’s 

electrolytic capacitors to discharge before proceeding to the next step.  Do 
not touch any internal parts with power applied to the drive, or for at 
least 5 minutes after power to the drive has been removed.  A hazard 
exists temporarily for electrical shock even if the source power has 
been removed.  Verify that the CHARGE LED has gone out before 
continuing the installation process. 

3.  Remove the drive’s display panel and front cover by inserting a flat-blade 

screwdriver into each of the two mounting tab access openings at the top 
of the front cover and depressing each of the mounting tabs (Figure 1).  
Rotate the top of the font cover outward and remove the cover (Figure 2).