Toshiba ASD-G9ETH 사용자 설명서

 

  

27

ICC 

parameter subgroups (if any) contained in that parameter group are displayed 
in the Parameter Subgroup Selection List (refer to section 10.4.3), and the 
corresponding parameters are displayed in the Parameter List (refer to section 
10.4.4).  The following parameter groups are available: 
 
All: All parameters are 
available (configuration, 
command and monitor 
parameters). 

Basic Parameters: Only 
the configuration 
parameters most commonly 
used for drive setup are 
available. 

Extended Parameters: All 
other configuration 
parameters that are not 
“basic parameters” are available. 

Command Parameters: Only drive command parameters are available.  Note 
that although all parameters associated with drive control are available in this 
selection, only those parameters that are identified as being for the “internal 
option board” can be used to actually control the drive via the option board:  all 
other drive command parameters can only be monitored via the option board. 

Monitor Parameters: Only drive monitor parameters are available. 
 
 

Subgroups can be used 
to further filter the 
parameters of a group 
that are to be displayed 
in the Parameter List.  
Refer to Figure 12. 
 
If the group currently 
selected in the 
Parameter Group 
Selection List (refer to 
section 0) has subgroups 
available, then choosing 
the desired subgroup will further filter the parameters that are displayed in the 
Parameter List.  If the currently-selected group does not have any available 
subgroups, then only the “All” subgroup will be shown, and all parameters in 
that group will be shown in the Parameter List.