Toshiba ASD-G9ETH 사용자 설명서
46
ICC
SMTP Authentication: Some email servers require that clients wishing to send
emails first authenticate themselves. If the email server in use requires
authentication, then enter the user name and password as indicated in Figure
42. If the email server in use does not require authentication, then these
entries can be disregarded.
When a test email transmission is initiated, completes successfully, or fails due
to an error, the information window (refer to section 10.9.1) will display
appropriate messages such as those shown in Figure 43 and Figure 44.
Although the test email is sent immediately, note that due to internet and/or
email server delays, it may take several minutes to receive test emails.
emails first authenticate themselves. If the email server in use requires
authentication, then enter the user name and password as indicated in Figure
42. If the email server in use does not require authentication, then these
entries can be disregarded.
When a test email transmission is initiated, completes successfully, or fails due
to an error, the information window (refer to section 10.9.1) will display
appropriate messages such as those shown in Figure 43 and Figure 44.
Although the test email is sent immediately, note that due to internet and/or
email server delays, it may take several minutes to receive test emails.
Figure 43: Information Window at Test Email Initiation
Figure 44: Information Window at Test Email Successful Completion
10.9.3 Alarm Configuration
The interface supports twenty independently-configurable alarms. As shown in
Figure 45, each alarm has a variety of configuration elements, which will be
explained further below.
Alarm Selection: This drop-down box allows the selection of one of the twenty
available alarms. When an alarm is selected, that alarm’s current configuration
parameters will be populated in the alarm configuration box.
“Enable” Check Box: If checked, this alarm is active and will be evaluated
every second. If unchecked, this alarm is inactive and will therefore not be
evaluated.
Figure 45, each alarm has a variety of configuration elements, which will be
explained further below.
Alarm Selection: This drop-down box allows the selection of one of the twenty
available alarms. When an alarm is selected, that alarm’s current configuration
parameters will be populated in the alarm configuration box.
“Enable” Check Box: If checked, this alarm is active and will be evaluated
every second. If unchecked, this alarm is inactive and will therefore not be
evaluated.